Table of Contents
Advertisement
Safety Instructions
For your protection please read these safety
instructions completely before you connect the
equipment to the power source. Carefully observe
all warnings, precautions and instructions
both on the apparatus and in these operating
instructions.
Retain this manual for future reference.
Water and Moisture
•
Do not operate the apparatus under or near
water—for example near a bathtub, kitchen
sink, or laundry tub, in a wet basement, near
a swimming pool or in other areas with high
humidity.
•
Never install jacks for communication cables
in wet locations unless the jack is specifically
designed for wet locations.
•
Do not touch the product with wet hands.
Cleaning
•
Unplug the apparatus from communication
lines, mains power-outlet or any power source
before cleaning or polishing.
•
Do not use liquid cleaners or aerosol cleaners.
•
Use a lint-free cloth lightly moistened
with water for cleaning the exterior of the
apparatus.
Ventilation
•
Do not block any of the ventilation openings
of the apparatus. Never cover the slots and
openings with a cloth or other material.
•
Never install the apparatus near heat sources
such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
•
Do not place the product in direct sunlight or
close to a surface directly heated by the sun.
Table of
Disclaimers,
Safety,
Contents
Patents etc.
Environmental
D13898.05
DECEMBER 2007
Lightning
•
Never use this apparatus, or connect/
disconnect communication cables or power
cables during lightning storms.
Dust
•
Do not operate the apparatus in areas with
high concentration of dust.
Vibration
•
Do not operate the apparatus in areas with
vibration or place it on an unstable surface.
Power Connection and Hazardous
Voltage
•
The product may have hazardous voltage
inside. Never attempt to open this product,
or any peripherals connected to the product,
where this action requires a tool.
•
This product should always be powered from
an earthed power outlet.
•
Never connect attached power supply cord to
other products.
In case any parts of the product have visual
damage never attempt to connect mains power,
or any other power source, before consulting
service personnel.
•
The plug connecting the power cord to the
product/power supply serves as the main
disconnect device for this equipment. The
power cord must always be easily accessible.
•
Route the power cord so as to avoid it being
walked on or pinched by items placed upon or
against it. Pay particular attention to the plugs,
receptacles and the point where the cord exits
from the apparatus.
•
Do not tug the power cord.
•
Introduction
Installation
Quick Setup
•
If the provided plug does not fit into your
outlet, consult an electrician.
•
Never install cables, or any peripherals,
without first unplugging the device from it's
power source.
Servicing
•
Do not attempt to service the apparatus
yourself as opening or removing covers may
expose you to dangerous voltages or other
hazards, and will void the warranty. Refer all
servicing to qualified service personnel.
•
Unplug the apparatus from its power source
and refer servicing to qualified personnel
under the following conditions:
•
If the power cord or plug is damaged or
frayed.
•
If liquid has been spilled into the apparatus.
•
If objects have fallen into the apparatus.
•
If the apparatus has been exposed to rain or
moisture.
•
If the apparatus has been subjected to
excessive shock by being dropped.
•
If the cabinet has been damaged.
•
If the apparatus seems to be overheated.
•
If the apparatus emits smoke or abnormal
odor.
•
If the apparatus fails to operate in
accordance with the operating instructions.
Backup and
Administrator
Operation
Restoring
10
TANDBERG
Accessories
•
Use only accessories specified by the
manufacturer, or sold with the apparatus.
Communication Lines
•
Do not use communication equipment to
report a gas leak in the vicinity of the leak.
Conference
View
Settings
Setup
Conferences
CONTENT SERVER
ADMINISTRATOR GUIDE
Appendices
Advertisement
Table of Contents
