Table of Contents
Advertisement
Installation
IMPORTANT!
If the power cord is damaged, it must be replaced by Residentia Group or one of it's authorised service
representatives. Please contact 1300 11 HELP (4357) and ensure the appliance is completely disconnected from
the power supply.
TRANSPORT
Move cautiously. Do not grasp any salient parts of machine. The machine door cannot be used as the handle
for transport.
If the appliance can't be transported upright the unit can be tilted at an angle no less than 30°.
Risk of injury and damage! Improper handling of the appliance may result in injury.
•
The appliance is very heavy. Never transport or carry the appliance alone; always with the assistance
of another person.
•
Remove all obstacles on the transport route and from the installation location, e.g. open doors and
clear away objects lying on the floor.
led and
•
Do not use the open door as a handhold.
•
Remove all package material before using the appliance.
•
Before setting up the washer dryer, check it for any externally visible damage.
he power
w
Do not install or use a damaged unit.
•
Do not install the unit in a room where there is a risk of frost occurring. At temperatures around freezing
W> 20mm
point the unit may not be able to operate properly. There is a risk of damage if the condensed water is
m the
allowed to freeze in the pump and hoses.
INSTALLATION POSITIONING
Ensure that the installation position adheres to the following conditions;
ed
1.
Rigid, dry, and level surface
2. Avoid direct sunlight
3. Sufficient ventilation
4. Room temperature is above 5°C
5. Keep far away from the heat sources such as coal or gas burning appliances
UNPACKING YOUR WASHER DRYER
WARNING! Packaging material (e.g. Films, Styrofoam) can be dangerous for children. There is a risk of
gas burning appliances.
suffocation! Keep all packaging well away from children.
1.
Remove the cardboard box and styrofoam packing.
2. Lift the washer dryer and remove the base packaging. Make sure the small triangle foam (a) is removed
with the bottom packaging together. If not, lay the unit down on the side surface and remove it manually.
3. Remove the tape securing the power supply cord and drain hose.
g.Make sure the small triangle
4. Remove the inlet hose from the drum.
her. If not, lay the unit down on
d drain hose.
w
a
8
Advertisement
Table of Contents
