Table of Contents
Advertisement
The list below shows the new zone types that apply to the PC40x0 v3.0 only.
Zone Type FB:
Interior Delay
Waterflow
Fire Supervisory
5.4
Default DVAC
Ref. # [00080102]
This command will restore the PC4400 programming
back to the default values. After you enter this section,
you will be prompted to confirm returning the PC4400 to
its default settings by pressing the [ ] key. The default
process has a duration of 10-15 seconds.
NOTE: When exiting installer's mode, if the panel
loses communication with the PC4400 module, the
message "DVAC module not present" will be dis-
played. If this occurs, check your wiring, then enter
and exit the installer's programming mode again.
If the Periodic UL Test reporting code is removed from
the panel, the DVAC Periodic UL Test transmission will
not be sent.
5.5
Trouble Conditions
The control panel always watches for possible trouble
conditions. If a trouble condition occurs, the keypad
"Trouble" light will turn on and the keypad will beep.
Press [ ][2] to display the trouble conditions.
The following trouble conditions apply to the PC4400
module. For a description of all troubles, please see your
system Installation Manual. Reporting codes for these
troubles can be programmed (ref. # [000403] OR scroll to
6
Alm
Rst
Byp
0A
8A
4A
00
80
40
01
81
41
firealarmresources.com
Trb
T_R
Sup
2A
AA
6A
20
A0
60
21
A1
61
System Area, then Communicator, then Reporting
Codes).
• Printer Off-line
• PC4400 Trouble
If programmed, the panel can also send reporting codes
for the following conditions:
• General System Tamper Alarm (PC4010/4020 v3.x and
higher)
• General System Tamper Restore (PC4010/4020 v3.x
and higher)
• General System Trouble (reported for DVAC Trouble
on PC4010/4020 v3.x and higher)
• General System Trouble Restore (reported for DVAC
Trouble Restore on PC4010/4020 v3.x and higher)
• PC4400 Tamper Alarm (PC4010/4020 v2.1 and lower)
• PC4400 Tamper Restore (PC4010/4020 v2.1 and lower)
• RS-232 Trouble (PC4010/4020 v2.1 and lower)
• RS-232 Trouble Restore (PC4010/4020 v2.1 and lower)
• DVAC Trouble (PC4010/4020 v2.1 and lower)
• DVAC Trouble Restore (PC4010/4020 v2.1 and lower)
Record your reporting code choices in the panel's Pro-
gramming Worksheets booklet.
S_R
Printer MSG
EA
Interior
E0
Fire
E1
Sprinkler
Advertisement
Table of Contents
