Table of Contents
Advertisement
A
U
D
I
3.7
Doorstrike Activation
Any intercom type station can be enabled to activate a doorstrike module while in communication
with a doorbox type station. After answering a doorbell page on an intercom station, press and
hold the Page/Answer button for 2 seconds to activate the doorstrike feature. An
acknowledgement beep will be heard. The PC5010 v1.XX will activate the sensor reset PGM,
or the PC5010 v2.XX will activate a command output PGM.
PC5010 v1.XX - The state of the sensor reset PGM can be normal or inverted
depending on Option 3 of the PGM attribute.
PC5010 v2.XX - Any command output programmed for doorstrike activation PGM
must have the Code Required option OFF (Option 5 of PGM attribute).
To terminate the communications with the doorbox station, simply press the Page/Answer
button briefly.
The doorstrike module must be wired to the appropriate PGM output on the PC5010.
3.8
Monitoring
The Monitor feature allows the user to listen to an area through all other stations. To turn on
the Monitor feature press and hold the Do Not Disturb button for two seconds on the desired
station. The station will be put in Do Not Disturb mode and the Do Not Disturb light will flash.
The PC5928 will transmit all sounds heard from the station to all the other stations on the
system, except for those on Do Not Disturb.
Other features such as paging, door answer and answering incoming calls can still be
performed and will override the Monitor feature. If a page, door answer or telephone call answer
is in progress the Monitor feature will not operate until the conversation is ended. To turn off the
Monitor feature press the Do Not Disturb button. The red light on the station will go out.
3.9
Answering Incoming Calls
When an incoming call is detected, the PC5928 will sound a ringing tone on all stations which
are enabled to sound the tone (unless on Do Not Disturb). To answer the call the user must
press the Page/Answer button for 1 second. Once the call is answered the audio channel will
operate the same as it does for a Page.
The call will end if the user presses and holds the Page/Answer button for 1 second. The call
will also end after 30 seconds of silence.
If a Page is in progress when an incoming call is detected the two persons on the Page will
hear the ring. To answer the call either person can press and hold the Page/Answer button for
1 second. The Page will end and the user will immediately be connected to the incoming call.
3.10
Transferring an Answered Call to the In-House Phones
Once a user has answered a call on a PC5921 Intercom Station, the call can be transferred
to an in-house telephone by simply going to the telephone, picking up the receiver and
pressing the [#] key for 1 second. This will put the call through to the telephone and
disconnect the PC5921 from the conversation.
3.11
Call Waiting
To answer a second call while on line with the first call, simply press the Page/Answer
button. This will function like pressing a telephone off-hook switch or "Flash" button. To
return to the first call, simply press the Page/Answer button again.
3.12
User Help (Keypad function Keys)
The following function keys can be used to broadcast Escort5580 voice prompts through the
PC5921 Intercom Station.
If the Escort5580 is on-line locally through an in-house telephone, the HELP function key will
not initiate User Help at the keypad.
If there is a telephone call in progress, User Help will override the call.
O
F
U
N
7
firealarmresources.com
C
T
I
O
N
S
Advertisement
Table of Contents
