Power Supply Options And Requirements - Sundance Spas 850 Series Owner's Manual

POWER SUPPLY OPTIONS AND REQUIREMENTS

Sundance hot tubs are designed to provide optimum performance and flexi-
bility of use when connected to the maximum electrical service as listed
below. However, they are shipped configured for the most commonly pre-
ferred electrical connection -- 50A, 240V
If you prefer, your Sundance dealer can perform a minor circuit board modifi-
cation to allow the hot tub to accept different electrical service. The opera-
tional considerations of these modifications are listed in the footnotes below.
CAMEO, OPTIMA, MARIN and ALTAMAR MODELS
Voltage
Current Draw
Number of Wires
Circuit Breaker
CAPRI
Voltage
Current Draw
Number of Wires
Circuit Breaker
*
In 50A configuration, the heater will not operate while both pumps are
operating at high speed. Note: pump 2 runs only in high speed.
**
In 30A configuration, the heater will not operate while either pump is
running in high speed or if the air blower is running. Note: pump 2 runs
only in high speed.
***
In 60A configuration, the heater will operate at the same time as the
high speed of both pumps and the air blower. Note: Not applicable for
1-pump Capri models.
Page 12
Table No. 1
**
240V/30A
240 volts
24 amps
Three
30A dual pole
**
240V/30A
240 volts
24 amps
Three
30A dual pole
*
*
240V/50A 240V/60A
240 volts
40 amps
Three
50A dual pole
*
240V/50A
240 volts
40 amps
Three
50A dual pole
***
240 volts
48 amps
Three
60A dual pole
***
240V/60A
N/A