Samsung AM Series Installation Manual page 7

7 Reassemble the Case-sides, tightening the screws after hanging the
set.
8 Hang the indoor unit to the suspension bolts between two nuts.
• Piping must be laid and connected inside the ceiling when
suspending the unit. If the ceiling is already constructed, lay the
CAUTION
piping into position for connection to the unit before
placing the unit inside the ceiling.
9 Screw the nuts to suspend the unit.
10 Adjust level of the unit by using measurement plate for all 4
sides.
For proper drainage of condensate, give a 1° or less slant to the side
of the unit which will be connected with the drain hose as shown in
NOTE
the figure. (The gap between the lower end of the indoor unit and
the ceiling should be 12 mm or less.)
Remove the Case-sides from the both of sides.
❈ ❈ The gap between the lower end of the
indoor unit and the ceiling should be
12 mm or less.
Wall
:The gap between the
❈ ❈ AM112JNCDKH
lower end of the indoor unit and the ceiling
should be 1˚ (23 mm) or less.
❈ ❈ AM140JNCDKH:The gap between the
lower end of the indoor unit and the ceiling
should be 1˚ (28 mm) or less.
❈ ❈ 1˚ or less
Connection pipe
Drain hose
Connection pipe
Drain hose
❈ ❈ 1˚ or less
7