Ceiling Installation - Samsung AM Series Installation Manual

Ceiling installation

It is recommended to install the Y-joint before installing the indoor
unit.
1 Select pipe directions.
When the directions are selected, drill 3-1/8''-(100mm, for pipe and
cables) and 1-3/4''-(40mm, for drain hose) diameter holes on the wall
so that it slants slightly downwards toward the outdoor for smooth
water flow.
Use the pattern sheet to select pipe directions.
NOTE
2 Drill holes for anchor bolts according to the distance and mount them.
Use the pattern sheet.
NOTE
3 Insert bolt anchors. Use existing ceiling supports or construct a
suitable support as shown in figure.
4 Install the suspension bolts depending on the ceiling type.
• Ensure that the ceiling is strong enough to support the weight
of the indoor unit. Before hanging the unit, test the strength of
CAUTION
each attached suspension bolt.
• If the length of suspension bolt is more than 1.5m, it is required
to prevent vibration.
• If this is not possible, create an opening on the false ceiling in
order to be able to use it to perform the required operations on
the indoor unit.
5 Screw eight nuts to the suspension bolts making space for hang-
ing the indoor unit.
• You must install all the suspension rods.
NOTE
6 When Hanging the Set, firstly unscrew the screws from the both of
sides, and then disassemble the Case-sides, or else the case-side will
be damaged by disassembling it directly.
6
300mm or more
Ceiling
Concrete
Hole in anchor
hole in plug
Suspension bolt(M10)-field supply
Ceiling support
Unscrew two screws from the both of sides.
300mm or more
Wall
50mm
Insert