Epoch Design Nara Bamboo Quick Start Manual

Nara Bamboo Platform Bed

Congratulations on the purchase of your Epoch Design Nara Bamboo Platform Bed.

This bed has been crafted to the highest standards of quality and safety and will give

you many years of enjoyment and practical use.

Since this is a natural bamboo wood product there will be variations in color and

grain, and minor wood grain checking may occur. This is normal and does not

compromise the integrity of your dresser. Variation in the character of wood is

integral to the beauty and appeal of this furniture, and distinguishes it from lower

quality materials.

On this insert you will find a list of the hardware and platform bed parts necessary for

assembly, as well as detailed instructions. Assembly is quite simple and requires only

a flat head screwdriver and a Phillips head screwdriver. The use of a power drill with a

Phillips head attachment and a clutch set on low is helpful but not necessary.

Assembly will be most easily accomplished if you take the time to carefully sort the

hardware and familiarize yourself with the function of each piece.

If you should require assistance with assembly, part replacement or any other matter,

contact the toll-free Epoch Design Service Center from anywhere in the Continental

United States, Monday through Friday, 9AM-5PM Pacific Standard Time at (800)

589-7990. You may also fax your request or comments to (425) 284-0885 and/or

email to info@epochbydesign.com and a service representative will respond.

Thank you and Enjoy

Table of Contents

Need help?

Do you have a question about the Nara Bamboo and is the answer not in the manual?

Page 1 Nara Bamboo Platform Bed Congratulations on the purchase of your Epoch Design Nara Bamboo Platform Bed. This bed has been crafted to the highest standards of quality and safety and will give you many years of enjoyment and practical use.
Page 2 STEP 1 Using 4 x 110mm bolts and 4 x barrel nuts attach the bed rails to the head- Figure 1 board as shown in Figure 1. Note: Do one rail at a time and only hand tighten the bolts at this time. Figure 2 STEP 2 Insert all 4 of the threaded steel...
Page 3 STEP 4 Insert the center support rail into these brackets as shown in Figure 4. Figure 4 STEP 5 Lay out the slats evenly on bed, strap side down. Screw the slat closest to the headboard rst against the two outside rails. Secondly screw the slat closest to the footboard to the two outside rails.
Page 4 Nara Bamboo Platform Bed Hardware & Parts List 2 x SIDE RAILS 1 x HEADBOARD 1 x CENTER SUPPORT 16 x SLATS 1 x FOOTBOARD 4 x BRACKET ASSEMBLIES 2 x CENTER SUPPORT BRACKETS 4 x 110mm BOLTS 1 x WRENCH...