Auto Oscillation; Sleep Mode; Water Drainage - NewAir NAC12KWH03 Owner's Manual

To set a timer for powering off:
• When the air conditioner is on, press the TIMER button and select a desired
OFF time by using the time settings buttons.
• "Preset OFF Time" will be displayed on the operation panel.
• "OFF time" can be set for any time from 0-24 hours.
• Press the TIMER button again to confirm settings. Timer indicator light will
illuminate.
• To deactivate the timer function, press the TIMER button until timer
indicator light turns off.

AUTO OSCILLATION

After the unit turns on, press the OSCILLATE button. The louver will then move
continuously up and down. By pressing this button again, the movement will
stop, and the louver will remain in the stopped position.

SLEEP MODE

• While in cooling mode, press the SLEEP button to set the desired starting
temperature. The set temperature will increase by 2°F after one hour and
4°F after 2 hours.
• Press the SLEEP button again to cancel these settings.

WATER DRAINAGE

Water Tray Full Alarm
The water tray inside the air-conditioner has a water level safety switch that
controls the water level. When the water level reaches a specified height, the
associated indicator light will illuminate. (If water pump is damaged, when the
water tray is full, please remove the rubber plug at the bottom of the unit, to
drain water).
Continuous Drainage
• If you plan to leave this unit unused for an extended time, please remove
the rubber plug from the drainage hole at the bottom of the unit and
connect a drain hose to the lower fixing clip.
• You can also drain the water this way when the unit is operating in HEAT
mode.
www.newair.com
EN
21