Connect Rj10 Cable(S); Connect Bms Cables - Victron energy Lynx Smart BMS 500 Manual

Lynx Smart BMS

5.3.2. Connect RJ10 cable(s)

These instructions only apply, if the system contains Lynx Distributor(s).
There are two RJ10 connectors in each Lynx module, one on the left and one on the right. See below drawing.
RJ10 connector RJ10 connector
RJ10 connector
RJ10 connector
RJ10 connector RJ10 connector
Recess
Recess Recess Recess
Locations of the RJ10 connectors and RJ10 cable recesses on the Lynx Distributor, Lynx Smart BMS and the Lynx VE.Can
To connect the RJ10 cables between the Lynx Smart BMS and Lynx Distributor, do the following:
• Plug one side of the RJ10 cable in the RJ10 connector of the Lynx Distributor, with the retainer clip of the RJ10 connector
facing away from you.
• Feed the RJ10 cable through the recess at the bottom of the Lynx Distributor, see above picture.
• Plug the RJ10 cable into the RJ10 connector at the bottom of the Lynx Smart BMS.
Connection example Lynx Smart BMS system - RJ10 cables indicated in yellow

5.3.3. Connect BMS cables

Connect the BMS cables from the lithium battery to the BMS connectors on the Lynx Smart BMS.
BMS connectors
Location of the BMS cable connectors
In case multiple batteries (up to 26 batteries can be connected to the BMS) are used, first interconnect the battery BMS cables
and then connect the BMS cable from the first and last battery to the BMS connectors on the Lynx Smart BMS.
If the BMS cables are too short, use BMS extension cables.
Page 8 Installation