Wi-Fi Protected Setup (Wps) Setup; How To Disable The Wi-Fi Network Connected - G&G P2022 Series User Manual

• If the printer cannot be used normally after wireless network setup is finished, please
Note：
install the drive again.

5.1.2. Wi-Fi Protected Setup (WPS) setup

If the access point (wireless router) supports Wi-Fi Protected Setup (WPS), the Wi-Fi key on the
control panel of printer and WPS key on access point (wireless router) can be pressed in order to
connect the printer to wireless network.
5.1.2.1. Preliminary preparations
1. The access point (wireless router) supports Wi-Fi Protected Setup (WPS).
2. A printer that has wireless network function.
5.1.2.2. Wi-Fi Protected Setup (WPS) method
1. Turn on the power of printer and access point (wireless router).
2. Make sure the printer is in ready state.
• If the printer is in sleep mode, it can be woken up by pressing any key on the control
Note：
panel of printer.
3. Press the "Wi-Fi key" on the control panel of printer for more than 2s until the blue Wi-Fi indicator
of printer blinks, and then release pressing.
4. Press the WPS key on access point (wireless router) within 2min and then release it.
5. When the access point (wireless router) and printer start to connect, the blue Wi-Fi indicator of
printer starts to blink. The blue Wi-Fi indicator of printer will be normally on after successful
connection.
If the connection is not established after more than 2min, the printer will return to its ready state, the
Wi-Fi indicator will be off and Wi-Fi Protected Setup (WPS) connection will fail. If it is needed to
connect again, please repeat steps 3-4 above.
• After successful Wi-Fi Protected Setup (WPS) connection, please install a driver if
Note：
you want to print via wireless network.

5.1.3. How to disable the Wi-Fi network connected

Please complete the wireless network connection in infrastructure mode according to above steps.
If connected, the Wi-Fi indicator on the status control panel will be always on; now if you want to
disconnect it, please press and hold this key for more than 2 seconds (the Wi-Fi indicator will be
off ).
49