Wired Network Settings (For Wired Network Printer Models); Set Ip Address - G&G P2022 Series User Manual

4. Wired Network Settings (For wired network
printer models)
You may need to set some network parameters on the printer. These parameters can be set from
the embedded Web server.
• Due to printer upgrades, some functions may be different, depending on the model
Note：
you purchased. If you have any questions, please contact G&G Customer Service.

4.1. Set IP Address

The IP address of the printer may be automatically obtained through DHCP function or set
manually.
| Automatic Setting
DHCP automatic setting function is enabled by default on the printer.
1. Connect the printer to the network through a network cable and complete the startup preparation
work.
2. The printer will automatically obtain the IP address assigned by the server. The IP address
obtained automatically can be used after a few minutes.
• If DHCP cannot automatically obtain the IP address, the printer will automatically use the
Note:
default IP address: 169.254.xx.xx.
• Due to the features of DHCP, the IP address of the printer automatically assigned by the
network may vary if the printer has not been used for a long time or the network access
point changes, which could result in unsuccessful connection to the printer. It is
recommended that the IP address automatically assigned by the network is bound to the
Mac address of the printer while the DHCP function is enabled.
| Manual Setting
Type the IP address in the Web browser's address bar to open the embedded Web server.
1. Click Settings in the navigation bar to open the Settings page;
2. Select Network Settings - IPV4 Settings;
3. Set IP Address Assignment Mode (Manual), IP Address and Subnet Mask. Other items are
optional;
4. Click Apply to save the settings.
• You can use the embedded Web server to change the IP Address Assignment Mode
Note:
into Automatic or Manual.
40