Lumineux Stanford Anti-Corrosive Installation Instructions

Stanford
Anti-Corrosive
Single & Twin
1

READ THESE INSTRUCTIONS

THOROUGHLY BEFORE
INSTALLATION KEEP THESE
INSTRUCTIONS FOR
FUTURE REFERENCE.

IMPORTANT:

This product must be installed
by a qualifi ed electrician or
competent person, and in
accordance with current building
and IET wiring regulations.

BOX CONTENTS

This lighting fi xture has been properly
packed to avoid damage during
transit. Before commencing with the
installation carefully inspect the
4
luminaire to confi rm there is no
damage. DO NOT INSTALL if any
damage has occurred to the fi xture
or any of its components.
• Light Fitting
• Instruction Manual
• Brackets
• Cable Gland

TOOLS REQUIRED

• Drill
• Screwdriver
• Cable
A
D D Manby Business Park, Manby, Lincolnshire, LN11 8UT
G Lumineux is a B&T Associates Ltd company.
19W, 27W & 38W Single / 38W, 57W & 72W Twin
POWERED BY : ENEC
INSTALLATION INSTRUCTIONS
2
on
off
5

Electrical connection wiring

NEUTRAL = Blue
EARTH = Green/Yellow
LIVE (SW) = Brown
Technical Helpline: +44 (0)1507 328031
50,000
5 YR
IP65 IK08
Warranty
Hours
3
6
1. Route the correct 3-core or 4-core cable type
2. Secure the mounting brackets into position using
3. Release the light fi tting locking clips to remove
4. Fit cable gland (supplied)
5. Thread the cable through the gland and connect to
on
6. Switch the mains power on and check the luminaire
off
Stanford
PLEASE READ THESE INSTRUCTIONS
BEFORE INSTALLATION.
WARNING: Risk of electric shock! Isolate
the mains power before proceeding.
• Turn off the mains power before performing
inspections, installation, or removal
• Verify that the supply voltage is correct by
comparing it with the luminaire label information
• It is the installers responsibility to ensure installation
is suitable for the total load of the luminaire(s). The
supply cable, fuses/circuit brakers must be correctly
rated for the electrical load and considering for any
transient inrush currents that may occur
• Do not perform insulation strength or resistance
tests on installed luminarie(s) connected
according to the location of the light fi tting, i.e.
outdoor location requires H05RN-F (1.0mm
waterproof cable
suitable wall fi xings and screws according to the
size (LF) of the light fi tting (1)
the diffuser (2) and release the LED gear tray using
the twist-clips, set aside (3)
gear tray terminal as shown depending on fi xture
type (4) and tighten the cable gland, refi t the
geartray and diffuser on completion (6)
illuminates or proceed to microwave and
emergency unit settings
www.lumineux.co.uk
2
)