KSW4000 Series | 3. Operation
3. Operation
34
• For incident light, insert the lightguide into the lamp
holder on the rear side.
• Insert the plug into the mains connection jack and the
transformer into the 220 V outlet.
• Place the material to be examined on the supporting
plate and illuminate, if applicable.
• Look through the eyepiece.
• Release the locking screw of the head and move
the head up and down until there is a clear image.
Now fasten the screw again.
• Turn the focus adjustment knob slowly, to get a sharp
image of the material.
• Move both eyepieces until they match your eye
distance.
• Look with your right eye through the right eyepiece
and focus the image using the focus adjustment knob.
• Now look with your left eye through the left eyepiece
and focus the image using the diopter adjustment
without changing the focus adjustment.
• The main switch turns all of the illumination on or off.
The 3-way switch in the neutral position is the OFF
position. By moving the switch forward, you turn on
the incident light, by moving backwards, you turn on
the transmitted light.