DAYLIFF SUNVERTER B Installation & Operating Manual page 8

DANGER
WARNING
WARNING
Shielded cables must be used for encoders, sensors and other
s u s c e p t i b l e c o m p o n e n t s a n d r e l i a b l y g r o u n d e d .
WARNING
Cables, circuit breakers, contactors and other components
must be selected as required by the manual.
WARNING
Strictly follow the screen printing on the inverter during the
wiring and do not connect the input and the output inversely,
otherwise it can damage the device.
WARNING
Do not install compensation capacitors or surge suppressors
at the output of the inverter, otherwise it may cause overheat
and damage the inverter.
WARNING
2.4 Operation
DANGER
DANGER
DANGER
The inverter must be grounded reliably, otherwise it may
cause electric shock.
The terminal signal cable of the inverter should be put away
from the power cable as far as possible. If the distance is not
enough, they should be cross-distributed vertically,
otherwise it will cause signal interference.
Make sure all terminal screws are tightened while wiring,
otherwise it may damage the device.
Make sure all the wiring and connections are correct and the
case cover is close before powering on.
Do not remove cover plate after powering on, otherwise it
may cause electric shock.
Do not perform any operation other than the panel setting on
the inverter during running, otherwise it may cause electric
shock or damage the device.
5