Husqvarna DM 220 Operator's Manual page 14

10. Lift the drill bit to the ceiling. Attach the slurry ring to
the ceiling.
To decrease the temperature of the
motor
• Operate the product with no load for 2 minutes to
decrease the temperature of the motor.
To change gear
CAUTION:
motor decreases in speed or stops. Do not
use force to change gear.
• Use the applicable speed for the drill bit diameter.
Refer to the rating plate on the product or
data on page 22 .
• Turn the drill spindle and at the same time turn the
gear selector to change gear.
To drill a hole at a specified angle
The product has an electronic level indicator that senses
the angle of the product. The electronic level indicator
helps the operator to drill in the specified angle.
14
Change gear only when the
Technical
1. Push the ON/OFF button to start the electronic level
indicator.
2. If it is necessary, do a configuration of the electronic
level indicator. Refer to
electronic level indicator on page 15 .
3. If the middle green LED (A) comes on, the product is
correctly aligned horizontally and vertically.
4. If a red light comes on, the product must be tilted
to adjust the position of the product. Do 1 of the
procedure that follows.
To do a configuration of the
A
1794 - 001 - 24.03.2022