Table of Contents
Advertisement
Service Manual
12. Adjustment of meshing position of gears for
take-up lever
Checking
1. If excessive noise is generated from take-up lever, there should be a problem in
meshing of take-up operating gear (A) with main shaft gear.
2. Remove front cover and check play of gear (A) by turning take-up operating gear (B) by
hand:
There should not be play at 4 positions of the gear and it should not be tightened too
much.
３．Also check to see if there is no play of gear (A) vertically.
Adjustment
1. Loosen screws (D & E) fixing eccentric gear shaft (C).
2. Adjust by turning gear shaft (C) slightly while pushing it with screw driver as shown,
since the gear shaft tends to pop up.
D
3. Tighten the screw (D) and then screw (E) securely after adjustment.
B
A
A
E
Original issue
Oct.2012
Page 26/41
Model
One Plus
C
Advertisement
Table of Contents
