Stadler Form Albert Operation Instructions Manual page 23

• The dehumidifier must always be operated according to this instruction
manual. Non-observance of these instructions can lead to injuries, a fire,
electric shock or faults in the appliance.
• The dehumidifier is designed for private use indoors and is not intended
for commercial use.
• Do not use the dehumidifier if it is faulty or could show signs of damage, or
if it is not functioning correctly. Disconnect the plug from the power socket.
• The appliance shall be installed in accordance with national wiring
regulations.
Setting up / operation
1. Place Albert on a flat surface in the desired area. Plug the power cable
(16) into an electric socket.
2. Press the on/off switch (3) to turn on the dehumidifier.
3. You can select the speed of the fan in the dehumidifier by pushing the
speed level selector (5). There are 3 speed levels. If the speed is higher,
the dehumidifying performance also increases.
4. With the hygrostat (4) the desired humidity level can be set. Press on
the knob hygrostat (4) and change to desired humidity level with the
rotary control (10). Humidity levels between 30 and 80 % or continuous
running (CO in display) can be selected. A humidity level not higher
than 60 % is suggested in general. If the dehumidifier reached the
selected humidity it will turn off and after that check the humidity level
in constant intervals by turning on the fan for a short time.
5. With the timer you can select precisely when Albert should be running.
The timer can be activated by pressing the knob timer on/off (6) and the
LED will be lit. If you press the knob again the timer will not be active and
the LED will be off. To set the timer follow these instructions:
6. Set the time: Press set (7) for 5 seconds and the symbol for hour is
shown blinking in the display, in addition the hours are blinking. Now you
can choose the correct hour with the rotary control (10). If the hours are
correct, press set (7) again and the minutes can be adjusted the same
way. To finish press set (7) again.
7. Set the timer: Press set (7) shortly and now you can set the time when
the unit should turn on (timer on) and the time when the unit should
stop (timer off), setting is the same as for the time above. If the timer
is activated (blue LED is on), the dehumidifier will start and stop every
day at the set time (this is ideal for example to use the cheaper power
tarifs at night).
8. The swing mode (8) allows to optimally distribute the dry air in the room.
This mode is also suitable for example to dry clothes fast and efficient.
9. If you find the display and LED too bright (in a bedroom for example), you
may reduce the light intensity by pressing the night mode (9).
10. Once the water tank is full, the blinking symbol will appear on the display
and the dehumidifier turns off automatically. Please empty the tank.
Once you put back the tank, the unit will automatically restart.
11. Defrost function: If the temperature in the room is below 10 °C, the
dehumidifier automatically runs in defrost mode. This mode is shown
on the display and frost build up in the unit will be avoided during
dehumidification. This function will be activated every 25 minutes for
a duration of 7 minutes.