Setting Your Wap3205 V3 To Ap Mode - ZyXEL Communications WAP3205 User Manual

•
C lie nt Bridg e
existing wireless router or access point in the network to which you want to connect your local
network wirelessly. In this mode, you should know the SSID and wireless security details of the access
point to which you want to connect.
Client Bridge
Fig ure 20
4.2 Se tting yo ur WAP3205 v3 to AP Mo de
Connect your computer to the LAN port of the WAP3205 v3.
1
The default LAN IP address of the WAP3205 v3 is 192.168.1.2. The WAP3205 v3 cannot assign your
2
computer an IP address, so you must give it a fixed IP address in the range between 192.168.1.3 and
192.168.1.254
After you've set your computer's IP address, open a web browser such as Internet Explorer and type the
3
IP address of the WAP3205 v3 as the web address in your web browser.
Log into the Web Configurator. See the
4
Go to
5
O pe ra tio n Mo de > G e ne ra l
A pop-up window appears providing information on this mode. Click
6
window. Click
Note: Wait while the WAP3205 v3 restarts, then log in to the Web Configurator again.
Chapter 4 Modes
: Use this mode to have the WAP3205 v3 (N) work only as a wireless client if there is an
(Section 2.2 on page 14).
and select
. Your WAP3205 v3 is now in
Apply
WAP3205 v3 User's Guide
Chapter 2 on page 14 for instructions on how to do this.
.
Ac c e ss Po int
.
AP Mo de
34
in the pop-up message
O K