Sony WEGA KP-FX432 Operating Instructions Manual page 58

Troubleshooting (continued)
Symptom
• The power cord,
No picture
• The projection TV is not
No sound
• The volume level is
Good picture
• The sound is muted.
• The broadcast signal
No sound
• The sound of the
• There is local
Dotted lines or
stripes
• Broadcast signals are
Double images or
"ghosts"
• The antenna direction
• Use of a booster is
• The color level
No color
• The color system setting
• The antenna direction
58
Additional Information
Possible cause
antenna or VCR is not
connected.
turned on.
too low.
has a transmission
problem.
right picture is
selected when TWIN
pictures are
displayed.
interference from
cars, neon signs, hair
dryers, power
generators, etc.
reflected by nearby
mountains or
buildings.
needs adjustment.
inappropriate.
setting is too low.
is inappropriate.
needs adjustment.
Solutions
• Check the power cord, antenna and
the VCR connections.
• Press I/1 on the remote.
• Press ! on the projection TV to turn
off the projection TV for about five
seconds, then turn it on again.
• Press 2 + to increase the volume
level.
• Press % to cancel the muting.
• Press A/B until a better sound is
heard.
• Press or .
• Do not use a hair dryer or other
equipment near the projection TV.
• Adjust the antenna direction for
minimum interference. Contact a
Sony dealer for advice.
• Use a highly directional antenna.
• Use the fine tuning ("Fine") function.
• Adjust the antenna direction. Contact
a Sony dealer for advice.
• Turn off or disconnect the booster if
it is in use.
• Display the "Picture" menu and select
"Personal" of "Picture Mode", then adjust
the "Color" level under "Picture
Adjustment".
• Display the "Setup" menu and check
the color system ("Color System")
setting (usually set this to "Auto").
• Adjust the antenna direction. Contact
a Sony dealer for advice.
Page
7
16
17
17
17
27
22
–
–
–
50
–
–
40
47
–