Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS – ROLLER & ROLLER MOUNT ASSEMBLY
1. Review all directions and diagrams provided before starting roller and roller mount
installation.
2. Locate position for roller mount brackets (Pt. No. 32H03) between cross sills of the
container. Rollers should be positioned as far back and as wide as possible for stability.
For hoist and folding bumper clearance, do not place brackets any closer than 11" to the
subframe longsill (see Fig. A). Also, the roller axle center line should be approximately 1-
11/16" below the bottom of the subframe longsill for roller clearance (see Fig. A).
3. Some modification to the roller mount bracket may be required for the roller mount to fit
properly. If the existing container cross members are wider than 6", a fabricated support
member of 1/2" plate or thicker will need to be added (see Fig. B).
2.9.INS.ACC.10H90
Section II: Installation - Accessories
Figure A
2-27
Advertisement
Table of Contents
