Efco swaploader SL-105 Parts And Operation Manual page 33

INSTALLATION INSTRUCTIONS – FENDER ASSEMBLY, SINGLE AXLE
1. Review all directions and diagrams provided before starting fender installation.
2. Center fender above tire using block to
maintain the proper height. Fender should be
approximately 5" above tire to allow for
suspension movement (see Fig. A). A
maximum width of 48" from center of the truck
to the outside edge of the fender should be
maintained (see Fig. B).
3. Place fender bracket weldments (Pt. No.
10H74) on fender. Position the brackets to
avoid any mounting obstacles on hoist and/or
truck chassis.
4. Mark mounting holes through the fender
bracket weldment onto the fender. Remove
the bracket and drill Ø7/16" holes in fender
(see Fig. C).
5. Attach fender bracket weldments to ender
using fasteners provided.
6. Weld mounting plates (Pt. No. 21H37) to
fender tubes (Pt. No. 21H61).
7. Position fender tubes with mount plates on
hoist main frame; align with fender bracket
weldments. (NOTE: Fender tube length
may need to be modified to fit specific
application.)
8. Weld fender tubes to hoist main frame. If
attaching the fender tubes to the truck
chassis, an additional mount plate may
need to be fabricated so the assembly can
be bolted to the truck chassis.
9. Attach fender bracket weldment (Pt. No.
10H74) to mounting plate (Pt. No. 21H37)
using fasteners provided (see Fig. C).
2.7.INS.ACC.10H93
Section II: Installation - Accessories
Figure A
Figure B
2-21