Trill Configuration Example; Network Requirements - H3C S10500 Series Configuration Manual

Task
Display brief TRILL information.
Display TRILL FIB information.
Display TRILL GR status.
Display TRILL ingress forwarding
information.
Display TRILL port information.
Display TRILL LSDB information.
Display all ingress entries in the
TRILL multicast FIB (MFIB).
Display all egress entries in the
TRILL MFIB.
Display information about the TRILL
multicast routing table.
Display the TRILL neighbor table.
Display TRILL neighbor statistics.
Display the TRILL RPF check table
information.
Display TRILL topology information.
Display information about the TRILL
unicast routing table.
Clear dynamic running statistics of
the TRILL process.

TRILL configuration example

Network requirements

As shown in
layer, and access layer. A port connected to a higher layer device is an uplink port, and a port
connected to a lower layer device is a downlink port.
Configure TRILL in the network as follows:
•
Enable TRILL on the downlink ports of access layer devices to connect terminal devices to the
TRILL network.
•
Enable TRILL on the uplink ports of access layer devices, and configure these uplink ports as
trunk ports to pass TRILL frames to the TRILL network.
•
Enable TRILL on the downlink ports of distribution layer devices, and configure these downlink
ports as trunk ports to forward TRILL data frames.
•
Enable TRILL on the uplink ports of the distribution layer devices. These ports send the
de-encapsulated TRILL data frames to the core layer.
•
In the TRILL network, configure four TRILL distribution trees with RB 6 through RB 9 as the root
bridges. RB 6 through RB 9 are in descending priority order.
Figure 5, a Layer 2 data center network has three layers: the core layer, distribution
Command
display trill brief
display trill fib [ count | nickname nickname ]
display trill graceful-restart status
display trill ingress-route [ vlan vlan-list ]
display trill interface [ interface-type interface-number ]
display trill lsdb [ local | lsp-id lsp-id | verbose ] *
display trill mfib ingress [ vlan vlan-id [ local-entry |
remote-entry ] ]
display trill mfib transit [ nickname nickname [ prune-entry |
rpf-entry | vlan vlan-id [ mac-address mac-address ] ] ]
display trill multicast-route [ tree-root nickname [ vlan vlan-list
[ mac mac-address ] ] ]
display trill neighbor-table
display trill peer [ interface interface-type interface-number ]
display trill rpf-table tree-root nickname
display trill topology [ verbose ]
display trill unicast-route [ nickname nickname ] [ verbose ]
reset trill
19