Trill Configuration Task List; Enabling Trill; Configuration Restrictions And Guidelines; Configuration Procedure - H3C S10500 Series Configuration Manual

TRILL configuration task list

Tasks at a glance
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.) Configuring TRILL LSP parameters and features
(Optional.)
(Optional.)
(Optional.)
(Optional.) Enabling incremental flush for TRILL multicast routing entries
(Optional.)
(Optional.)
(Optional.)
(Optional.) Associating a TRILL port with a track entry

Enabling TRILL

After you enable TRILL on a port, TRILL can operate correctly by using default settings. A port with
TRILL enabled is called a TRILL port.

Configuration restrictions and guidelines

To enable TRILL on a port, first enable TRILL globally.

Configuration procedure

To enable TRILL:
Step
Enter system view.
1.
Enable TRILL globally
2.
and enter TRILL view.
Return to system view.
3.
Enter Layer 2 Ethernet
4.
or aggregate interface
view.
Enabling TRILL
Configuring the system ID and nickname for an RB
Configuring the link type of a TRILL port
Configuring the DRB priority of a TRILL port
Configuring the link cost for a TRILL port
Configuring announcing VLANs and the designated VLAN
Configuring TRILL timers
Setting the SPF algorithm parameters
Configuring TRILL distribution trees
Configuring TRILL ECMP routes
Enabling logging of TRILL neighbor changes
Configuring SNMP for TRILL
Configuring TRILL GR
Command
system-view
trill
quit
interface interface-type
interface-number
Remarks
N/A
By default, TRILL is disabled globally.
N/A
N/A
7