Improper Network Cabling And Topology - ZyXEL Communications GS1100 Series User Manual

The LED on the front panel does not light up.
PWR
• Check the connections from your Switch to the power source. Make sure you are using the supplied
power cord and that you are using an appropriate power source. Refer to the product specifications.
• Make sure the power source is turned on and that the Switch is receiving sufficient power.
• If these steps fail to correct the problem, contact your local distributor for assistance.
The , or
L NK/ A C T 1G
• Verify that the attached device(s) is turned on and properly connected to your Switch.
• Make sure the network adapters are working on the attached devices.
• Verify that proper network cable type is used and its length does not exceed 100 meters. For more
information on network cable types, see
The LED is off and/or power is not being supplied to my PoE-enabled device.
Po E
• Make sure that your Switch supports PoE - see
• Check to see that the power adaptor is securely connected to the Switch and an appropriate power
source. Make sure the power source is on and functioning properly.
• Check that the Ethernet cables are connected properly and that you are using the correct type of
Ethernet cable. Contact your local distributor if the problem persists.
4.2 Im pro pe r Ne two rk C a b ling a nd T o po lo g y
Improper network cabling or topology setup is a common cause of poor network performance or even
network failure.
Figure 30 Troubleshooting Improper Network Cabling and Topology
PRO BL EM
Faulty cables
Non-standard
network cables
Cabling Length
Chapter 4 Troubleshooting
LED does not light up when a device is connected.
10/ 100
C O RREC T IVE AC T IO N
Using faulty network cables may affect data rates and have an impact on your network
performance. Replace with new standard network cables.
Non-standard cables may increase the number of network collisions and cause other network
problems that affect your network performance. Refer to
information on network cable types.
If you use longer cables than are needed, transmission quality may be affected.
The network cables should not be longer than the limit of 100 meters.
GS1100 Series User's Guide
Table 4 on page 20.
Table 1 on page 8.
29
Table 4 on page 20 for more