Haas EC-400 Disassembly

Pallet changer

Haas Technical Documentation

EC-400 - Pallet Changer - Disassembly

EC-400 - Pallet Changer - Disassembly - Introduction

Make sure the machine is turned off and the air pressure is discharged before attempting to work on this

machine.

The drive mechanism for the apc is located inside the rotating door. It can be accessed for troubleshooting by

removing either half of the door. Apc disassembly requires removing the door. Disassembly is a top down

process.

Effective Date:

September, 2003

Page 1 of 3

Table of Contents

Do you have a question about the EC-400 and is the answer not in the manual?

Page 1 The drive mechanism for the apc is located inside the rotating door. It can be accessed for troubleshooting by removing either half of the door. Apc disassembly requires removing the door. Disassembly is a top down process. © Copyright 2015 by Haas Automation, Inc. No unauthorized reproduction. Page 1 of 3...
Page 3 Reassemble the pallet changer in the order by which it was removed. Align the H-frame to the receiver pallet. Refer to EC-400 - Pallet Changer - Alignment. © Copyright 2015 by Haas Automation, Inc. No unauthorized reproduction. Page 3 of 3...