Advertisement
Items
(O)
Receive Audio
*
Check and
Confirmation
(P) Transmit Audio
Check and
Confirmation
Note:
After the measuring, sock up the solder of TP.
* :
PC Setting
() is required beforehand.
The connection of adjustment equipment are as shown in
15.2. Adjustment Standard (Handset)
When connecting the Simulator Equipments for checking, please refer to below.
Adjustment
Point
1. Configure the DECT tester (CMD60) as follows;
TP15
<Setting>
-Test mode: PP
-Mode: Nomal
-RFPI: 0102030405
2. Execute the command "testmode".
3. Execute the command "regcmd60"
4. Initiate connection from DECT tester.
5. Execute the command "openaudio".
6. Confirm that the value of EEPROM address "F3F" is "02". (If the value is not "02 (by
User)", set "02" and power off and power on, and return to clause 2.)
7. Input audio signal (50mVrms/1kHz tone) from DECT tester.
<DECT tester setting>
-Scramble: On
-AF Gen to ADPCM: On
-AF Meter Input: AF Voltm
-AF Gen Frequency: 1000Hz
-AF Gen Level: 50mVrms
8. Confirm hearing tone: 300mV ± 250mV (Just check Audio path)
9. Confirm that the audio distortion with DECT tester is < 5 %.
1. Configure the DECT tester (CMD60) as follows;
TP15
<Setting>
-Test mode: FP
-Mode: Normal
-RFPI: 0102030405
2. Execute the command "testmode".
3. Execute the command "regcmd60".
4. Initiate connection from DECT tester.
5. Execute the command "openaudio".
6. Confirm that the value of EEPROM address "F3F" is "02". (If the value is not "02 (by
User)", set "02" and power off and power on, and return to clause 2.)
7. Input audio signal (30mVrms/1kHz tone) to DECT tester.
<DECT tester setting>
-Scramble: On
-AF Gen to ADPCM: Off
-AF Meter Input: ADPCM
-AF Gen Frequency: 1000Hz
-AF Gen Level: 30mVrms
8. Confirm hearing tone: 300mV ± 250mV (Just check Audio path)
9. Confirm that the audio distortion with DECT tester is < 5 %.
Procedure*
Adjustment Standard (Handset)
47
Check
IC1,C67,C6
D7,D6,IC3,
C60,L3,C57
C62,R23,R2
IC1,C8,R7,
C7,C5,R5,
IC3,C54,C6
C57,C55,C5
R24,C63,C6
().
Advertisement
