HYOSUNG GV125S Owner's Manual page 88

Using a lamp bulb with
the wrong wattage rating can
cause electrical
damage or shorten bulb life.
Always use the specified
lamp bulb.
⊙ CHANGING THE HEAD
LAMP BULB
1. Remove
assembly from the head
lamp housing by loosening
the two screws , right and left,
and unhook the hook on the
top of
housing.
2. Disconnect the connector
from the
assembly.
3. Remove the rubber cap.
4. Unhook
spring and remove the bulb .
5. To install the head lamp,
reverse the above sequence.
system
the head lamp
the head lamp
head lamp
the bulb holder
⊙ CHANGING THE TURN
SIGNAL LAMP BULB
1.
Remove the lens by pushing
the groove ① of the turn
signal lamp housing using a
small flat screw driver.
2.
Turn
pushing counter-clockwise
and pull it out of the socket.
3.
Insert the new bulb into
the socket and turn it while
pushing clockwise.
4.
Install the lens by fitting
the groove ② of the lens in
the groove ① of the turn
signal lamp housing.
Don't use excessive force on
the lens.
It may cause a crack of the
lens.
⊙ CHANGING THE BRAKE /
TAIL / LICENSE PLATE LAMP
BULB
The motorcycle brake / tail /
license plate lamp is LED (Light
Emitting Diode) type.
If any abnormal condition
are found, replace the brake / tail
lamp assembly.
— 85 —
the bulb while