HYOSUNG GV125S Owner's Manual page 65

into the battery case.
3. Connect
battery wire at the battery
terminal.
4. Put on the rubber cap at the
⊕
positive terminal of the
battery.
Connect the ⊖ negative
5.
battery wire at the battery
terminal.
6. Install the battery support
and seat.
If connect the battery wire at
the battery first and then
install the battery into the
battery case, the battery will
be installed in the opposite
direction [the
terminal faces the right side of
the motorcycle] because the
length of
battery wire has no to spare.
If the battery is installed in
the opposite direction, the
battery can't be installed into
the battery case completely
and the electrical problem,
such as a short circuit, may
occur.
⊕
the positive
⊕ positive
⊕ positive
the
●
Keep the battery away
from fires.
●
When
battery
remove the ⊖ negative battery
wire first with the ignition
switch"
remove the ⊕ positive battery
wire.
When reinstalling the battery,
be sure to connect the ⊕
positive battery wire first,
then connect the ⊖ negative
battery wire.
●
Ensure the battery wires are
fastened tightly.
●
Incorrect
the battery will reverse the
terminal position resulting in
possible
damage
battery lead connection.
The red lead wire must go to
the ⊕ positive terminal and
the black (or black with white
tracer) lead wire must go to
the ⊖ negative terminal.
●
Never
while still in the machine as
damage may result to the
battery or regulator / rectifier.
— 62 —
disconnecting
wire, be sure
" position, then
installation
electrical system
due to incorrect
charge a battery
the
to
of