HYOSUNG GV125S Owner's Manual page 46

Do not attempt to start the
engine until the needle of the
speedometer completes a full
sweep and returns to the rest
position otherwise the engine
will start badly.
If the engine does not start
or runs badly,
ignition switch to the "
position. After 8 seconds,
turn the ignition switch to the
" ", allow the speedometer
needle to complete its sweep
and return
position and then attempt to
restart.
This allows the ISC (Idling
Speed Control) solenoid to
be initialized.
1
turn the
"
to the rest
— 43 —
If the engine warning lamp ①
does not come on when the
ignition switch is set to "
position with
stopped or fail to go out after
the engine start, contact an
authorized dealer.
The engine warning lamp ①
comes on and remains on when
the ignition switch is set to
" " position with the engine
stopped as a test of engine sys-
tem operation.
As soon as
starts, the engine warning
lamp ① should go out.
If the engine system fails,
the engine warning lamp ①
comes on and remains on.
Riding the motorcycle with
the engine warning lamp ① lit
after starting the engine can
damage the
transmission.
Whenever
warning lamp ① is lit while
riding the motorcycle, have
your authorized dealer or a
qualified
inspect the engine system
as soon as possible.
the engine
the engine
engine and
the engine
mechanic
"