Table of Contents
Advertisement
C
T
OMMAND
ILLER
1. Be sure that no one is near the machine prior to engaging or while the machine is
working.
2. Be sure the tractor is in "Neutral" before starting engine.
3. Tiller operating power is supplied from tractor PTO. Refer to your tractor manual for
PTO engagement and disengagement instructions. Always operate PTO at 540 rpm.
Know how to stop the tractor and tiller quickly in case of an emergency.
4. When engaging PTO, the engine rpm should always be low. Once engaged and
ready to start using, raise PTO speed to 540 rpm and maintain throughout operation.
5. Check the tractor master shield over the PTO stub shaft. Make sure it is in good
condition and fastened securely to the tractor. Purchase a new shield if old shield is
damaged or missing.
6. After striking an obstacle, disengage the PTO, shut the tractor down and thoroughly
inspect for damage before restarting.
7. Never engage the PTO until the tiller is in the down position and resting on the
ground. Never raise the tiller until the rotor has come to a complete stop.
1. Read and adhere to all safety and operating decals on this machine (see fig. 2).
2. Before dismounting tractor: Allow moving parts to stop, stop engine, set brake and
remove the key of unattended equipment.
3. Keep away from rotating blades and driveline.
4. Keep guards and shields in place and in good condition.
5. Do not use with bystanders in area.
6. Allow no riders on tractor or tiller.
7. Allow moving parts to stop before repair.
8. Securely support tiller before working underneath.
Additional warning and operating decals are available at no extra charge. Please specify
model and serial number when ordering.
S
P
AFETY
RECAUTIONS
2.02 - Starting and Stopping
2.03 - Messages and Signs
7
O
'
M
PERATOR
S
ANUAL
ABI A
TTACHMENTS
Advertisement
Table of Contents
