Table of Contents
Advertisement
C
T
O
'
M
OMMAND
ILLER
PERATOR
S
ANUAL
4.05 - Safety Slip Clutch
Fig. 18
spring nut
When the tiller is supplied with a safety slip clutch, it is important to ensure it is working
properly. The slip clutch delivered with your machine is set at a specific torque for
normal working conditions.
If the clutch slips frequently while the unit is working, it may be necessary to tighten the
spring nuts (see fig. 18) on the slip clutch. Tighten the spring nuts in ½ turn increments,
then test run the unit for 600 to 800 ft. Repeat the operation if necessary. The discs on
the clutch need to be replaced in the event that the clutch continues to slip even though
the spring nuts have been tightened.
Follow the instructions in reverse, if while working under normal conditions the clutch
does not slip at all.
M
29
ABI A
AINTENANCE
TTACHMENTS
Advertisement
Table of Contents
