Table of Contents
Advertisement
C
T
OMMAND
ILLER
(see #4, fig. 5); open the telescopic shield and bolt the outer cover to the retaining
plate on the sliding frame (see #1, fig. 6); ensure the telescopic shielding when open
does not touch the hexagonal shaft and is parallel as possible; slide the frame back
two or three times from completely open to completely closed to be sure it opens
and closes without difficulty. Note: Lightly greasing the hexagonal drive shaft helps
to side-shift the tiller.
1
2
3
6
9. Grease right rotor support bearing (see #4 & 5, fig. 3).
1
O
PERATION
4
5
2
3
Fig. 6
1. shield bolts
2. sliding frame support
3. U bolt
4. telescopic shield
5. right shield
5
1
6. gearbox holding bolt
6
4
14
O
'
M
PERATOR
S
Fig. 7
1. rear shield
2. adjustment chain
3. 'U' bolt
4. chain hitch
5. sliding frame
6. gearbox
ABI A
TTACHMENTS
ANUAL
Advertisement
Table of Contents
