Table of Contents
Advertisement
C
T
OMMAND
ILLER
5
6
1
5. Ensure the breather plug (see #2, fig. 4) is screwed into the chain case (see #3, fig.
4). Check the gearbox oil level (see #1, fig. 5). It should be between ½ and
Use SAE 90 wt. gear oil.
4
6. Check all hardware for proper torque
7. After shifting the sliding frame into its desired position, block it with both the front and
rear locking clamps U bolts (see #2, fig. 5)
assemblies. Grease sliding sections of shaft.
8. The hexagonal drive shaft is protected by a telescopic sliding shield (see #5, fig. 5).
To attach this shield do the following: bolt the upright tab to the chain case side plate
3
See Table 2, page 30 for proper torque specification.
4
See Section 3.03 - Side-Shift.
O
PERATION
2
3
5
2
4
1
3
3
.
4
. Grease driveline cross and bearing
13
O
PERATOR
Fig. 4
1. tiller stand
2. breather plug
3. chain case
4. rear shield
5. stand support
6. locking pin
Fig. 5
1. gearbox
2. locking clamps
3. sliding frame
4. side plate shield bolt
5. telescopic shield
ABI A
TTACHMENTS
'
M
S
ANUAL
2
/
full.
3
Advertisement
Table of Contents
