Table of Contents
Advertisement
C
T
OMMAND
ILLER
WARNING: Disengage PTO, wait for all movement from the implement and tractor
to stop, engage parking brake or place transmission in "Park", shut off the tractor
and remove the key before attaching the implement to the tractor.
To attach the tiller to the tractor do the following:
1. Back the tractor up to the machine in order to slip the tractor hitch arms over the
hitch pins attached to the sliding frame. Turn off the tractor engine.
2. The tiller hitch pin (#3, fig. 12) may be positioned in either the top or bottom hole,
depending on driveline length and tractor size.
3. Lock the tractor arms to the tiller hitch arms with the lynch pins. Stabilizers must be
used to limit side swing to 2" to 3".
4. Attach the top link. Adjust it so the tiller is as near parallel to the ground as possible.
A 1 to 2 degree rearward tilt is acceptable (see fig. 13).
5. Install the shielded driveline to the tractor by first lining up the splines and
depressing the snap pin. Push the yoke onto the PTO shaft as far as it will go.
Release the pin and pull back slowly until the pin clicks in place.
6. Repeat this operation on the implement end if the tiller is supplied with a shear
bolt.
7. If the implement is supplied with a slip clutch, first remove the sheet metal
protection on the gearbox, remove the locking bolt on the slip clutch yoke and push
the yoke on to the gearbox shaft. Line the locking bolt hole up with the groove on the
shaft. Reinstall the locking bolt and tighten down lock nut. Reinstall PTO protective
cover.
8. Attach the safety chains of the PTO shaft to the tiller and the tractor to keep the
shielding from rotating. Allow enough slack for the sliding plastic shielding to slide in
and out.
O
PERATION
3
19
2
Fig. 12
1
1. sliding frame
2. telescopic shield
3. hitch pin
O
'
M
PERATOR
S
ANUAL
ABI A
TTACHMENTS
Advertisement
Table of Contents
