Table of Contents
Advertisement
C
T
OMMAND
ILLER
23. Inspect the entire machine periodically
parts, and leaky or loose fittings.
24. Use only the driveline supplied with the equipment. Do not use it if it is missing any
shield or safety protection.
25. Pass diagonally through sharp dips and avoid sharp drops to prevent "hanging up"
tractor and implement.
26. Avoid sudden starts and stops while traveling up or downhill.
27. Always use down slopes; never across the face. Avoid operation on steep slopes.
Slow down on sharp turns and slopes to prevent tipping and/or loss of control.
CAUTION: Stand clear of bands when cutting as they could be under sufficient
tension to cause them to fly loose. Take care in removing bands and wire, they
often have extremely sharp edges and cut very easily.
Fig. 3
1. 3 point connecting bolt
2. top hitch support arm bolt
3. top hitch arm bolt
4
To assemble and setup the tiller for initial operation proceed as follows:
1. Lower the stand to support the tiller (see fig. 4). Secure it in place with the locking
pin.
2. Disassemble top and sides of the crate. Cut wires holding driveline. Leave machine
banded to pallet as long as possible to avoid tipping over during assembly.
3. Loosen bolts holding upper hitch in place in the shipping position.
4. Bolt the hitch together (see fig. 3), and bolt it to the tiller.
2
See Chapter 4 - Maintenance.
O
PERATION
3.02 - Setup and Lubrication
3
5
2
. Look for loose fasteners, worn or broken
2
4. grease fitting
5. right rotor support
12
O
'
M
PERATOR
S
ANUAL
1
ABI A
TTACHMENTS
Advertisement
Table of Contents
