Table of Contents
Advertisement
Available languages
Available languages
INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
The following basic safety precautions apply when
using electrical appliances:
• Read all instructions.
• Before use check that the voltage of wall outlet
correspond to the one shown on the rating plate.
• Do not operate any appliance with a damaged
cord or plug or after the appliance malfunctions, or
is dropped or damaged in any manner.
Return appliance to the nearest authorized
service facility for examination, repair or electrical
or mechanical adjustment.
• If the supply cord is damaged it must be replaced
by the manufacturer or a authorized service agent
or a qualified technician in order to avoid a hazard.
• To protect against risk of electrical shock do not
put in water or other liquid.
• Close supervision is necessary when any
appliance is used by or near children.
• Unplug from outlet not in use, before putting on or
taking off parts, and before cleaning.
• Avoid contacting moving parts.
• The use of attachments, including canning jars,
not recommended by the manufacturer may
cause a risk of injury to persons.
• Do not use outdoors
• Do not let cord hang over edge of a table or
counter.
• Do not let cord contact hot surface, including the
stove.
• Keep hands and utensils out of container while
blending to reduce the risk of severe injury to
persons or damage to the blender. A scraper may
be used but must be used only when the blender
is not running.
• To reduce the risk of injury, never place cutter-
assembly blades on base without jar properly
attached.
• Unplug the appliance immediately after use.
• Never let the appliance run unattended.
• Always operate blender with cover in place.
• If you use the blender have long time, you must
run it on 2 minute rest it 3 minute.
• Warning: never use hot liquids or run the
appliance empty.
• Blades are sharp. Handle carefully.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they
do not play with the appliance.
SAVE THESE INSTRUCTIONS!
HOW TO USE THE BLENDER
Before using for the first time, wash all parts and
attachments in hot soapy water, rinse and dry
thoroughly.
ASSEMBLE:
1. Put the motor housing on a steady and even
surface;
2. Screw the blade base with blade and water-proof
ring to the jug firmly;
3. Put the jug on the top of the coupling and turn
to connect it with the motor housing. Carefully
handle the blade because it is extremely sharp.
4. Place the lid firmly on the jug. Now this unit is
ready for use.
CAUTION: NEVER TURN ON THE APPLIANCE
UNTIL IT IS PROPERLY ASSEMBLED.
HOW TO OPERATE THE CONTROLS
The control dial is conveniently located on the front
of the base. Rotate the knob clockwise to select a
speed:
1 for Low
2 for High
For instant on and off control, use the PULSE (P)
button by rotating knob counterclockwise.
NOTES
• Wash ingredients well and cut into suitable
pieces to fit into the feeding hole. Add the foods
or beverages into the jug through the feeding
2
hole. The jug has a capacity of 1.5 liters. Do not
overload the jug at a time.
• The Pulse switch offers you fingertip control over
short food processing jobs. When switch to Pulse,
the machine will run at high speed.
• Turn Off to stop the machine.
NOTE: Do not let the machine work with thick
mixtures or heavy foods. If the motor does not run
freely, stop the machine and
• add a little liquid or
• switch to Pulse for a few short bursts or
• stop blending every few seconds and use a rube
spatula to clear the sides of the jug and push
ingredients towards the cutting blades, or
• reduce the contents in the jug
1. The appliance is only permitted to use 2min for
1 time. Before it is used again, it must cool down
enough.
2. When finished processing select OFF (0) or
release from PULSE position. Wait until blade
has stopped rotating before removing lid.
Unplug the unit
CLEANING AND MAINTENANCE
NOTE: MAKE SURE THE MACHINE IS OFF
AND PLUG IS DISCONNECTED FROM OUTLET
BEFORE PUTTING ON OR TAKING OFF ANY
PARTS.
1. Cleaning is best done immediately after use. Take
off the jug.
2. Particles of food lodging under the blade can be
easily removed with the aid of a small tooth brush
(not attached accessory).
WARNING: THE BLADE IS EXTREMELY SHARP.
HANDLE CAREFULLY.
3. Clean the motor housing with a soft damp cloth.
Do not use abrasive cleaners or scouring pads to
clean the unit. To clean the jug, add 1/4 teaspoon
(no more) of liquid detergent to the jug, and fill to
maximum with warm water. Place the jug on the
motor housing and pulse for a few seconds, two or
three times.
4. Rinse parts under running water. Do not use
a dishwasher or very hot water. Wipe all parts
thoroughly before putting them away after
use. Store the appliance in a dry place. It is
recommended to store the jug with the lid
removed.
CAUTION: NEVER IMMERSE THE MOTOR UNIT
OR POWER CORD INTO WATER FOR CLEANING.
If any problem has been encountered during use,
never disassemble the Motor Unit by yourself, there
are no user serviceable parts inside. Contact only the
authorized service facility for examination and repair.
TECHNICAL DATA:
220-240V ~ 50/60Hz • 500W
Environment friendly disposal
You can help protect the environment! Please
remember to respect the local regulations: hand
in the non-working electrical equipments to an
appropriate waste disposal center.
3
Advertisement
Table of Contents
