Sony WX-850BT Service Manual page 21

Hide thumbs Also See for WX-850BT:
Table of Contents

Advertisement

Installing the microphone
To capture your voice during handsfree calling, you
need to install the microphone
.
Clip (not supplied)
Cautions
It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
If airbags or any other shock-absorbing
equipment is in your car, contact the store where
you purchased this unit, or the car dealer, before
installation.
Note
Before attaching the double-sided tape
surface of the dashboard with a dry cloth.
Using the wired remote control
1
To enable the wired remote control, set
[STR CONTROL] in [SET STEERING] to
[PRESET].
Installation
Mounting the unit in the dashboard
When mounting in a Japanese car, see "Mounting
the unit in a Japanese car".
Mounting the unit with an installation kit
(not supplied)
You can use a commercially available double DIN
installation kit. Choose an installation kit with the
following panel frame size.
Larger than 172 × 97 mm (6
an inner corner radius of less than 0.5 mm (
Note
Be sure to use the supplied screws
Larger than
97 mm (3
7
/
in)
8
Larger than
172 mm (6
7
/
8
, clean the
7
/
× 3
7
/
in) (w/h), with
8
8
1
/
in).
32
.
to dashboard/center console
in)
Installation kit (not supplied)
WX-850BT/900BT/900BTM
Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.
to dashboard/center console
Bracket
Existing parts supplied
with your car
Bracket
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws
the appropriate screw holes, based on your car: T
for TOYOTA, M for MITSUBISHI and N for NISSAN.
Note
To prevent malfunction, install only with the supplied
screws
.
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
in
Fuse (10 A)
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wx-900btWx-900btm

Table of Contents