Table of Contents
Advertisement
WX-850BT/900BT/900BTM
How to display on the liquid crystal display by the
test mode:
1 In the state of source off (the clock is displayed on the
liquid crystal display), enter the test mode by pressing the
buttons in order of the [
(press only the [PAUSE 6] button for two seconds).
(Displayed characters/values in the following fi gure are
example)
Software main version
2 In the state in which the software main version is displayed
on the liquid crystal display, enter the Bluetooth address
(BD_ADDR) display mode by pressing the [DSPL
SCRL] button.
(Displayed characters/values in the following fi gure are
example)
Bluetooth address (BD_ADDR)
Note: When pressing the [DSPL SCRL] button again, the destina-
tion code is displayed on the liquid crystal display, but it is not
necessary to display in this step.
3 The resetting operation is executed by pressing the
[SOURCE OFF] button for 1 second after the confi rming
ends, and the unit returns to the normal condition.
2. Turn on the NFC function of the smartphone.
3. Start the NFC Tag Data Writing Application on the smart-
phone.
4. Tap the "Read" on the screen of the smartphone.
14
4] t [MIC 5] t [PAUSE 6]
5. Check that "BD_ADDR" on the screen of the smartphone ac-
cords with BD_ADDR written on the BT module label and
"MODE" on the screen of the smartphone is "00 00 (Read-
only)".
6. End the NFC Tag Data Writing Application on the smartphone.
Advertisement
Table of Contents
