Pan Acoustics P 8-15 Manual page 9

Manual
Step 2:
Insert the stripped wires into pin 1 and pin 2 of
the connection terminal. To do this, open the
screw blocks with a screwdriver. After insert-
ing the wires, close the screw blocks again and
tighten them with a torque of 0.4 Nm so that
the wires cannot slip out.
NOTICE
The wires of the connection cable must be fi tted
with wire end ferrules.
Step 3:
Insert the connection terminal with the cable
into the 5-pin connector on the loudspeaker.
© Pan Acoustics GmbH V 1.0 Page 9 of 24