Cleaning And Care - Klarstein ICEWIND PLUS SMART Manual

CLEANING AND CARE

Note: Switch the device off and unplug it before cleaning, repairing or
maintenance.
Cleaning
• If too much foreign matter or dust settles on the grille cover and the air inlet
rotors at the back of the unit, the wind effect will be impaired. It is therefore
recommended to clean them at least every two months.
• Switch off the device and unplug the power cord. Always disconnect the mains
plug before cleaning to avoid electric shocks or mechanical damage.
• Use a commercially available cleaning agent and a soft brush for cleaning. Do
not use chemical cleaners for cleaning.
Cleaning the outer surface of the device
• Wipe the surface with a damp cloth. Do not use water, as it could enter the
unit and damage the electronics.
• Do not use caustic cleaning agents or solvents.
Cleaning the filters
1. Press down the snaps of the dust filter and remove it.
2. Remove the water filter.
3. Vacuum the dust filter.
4. Place the water filter in a warm soap solution for a short time. Then rinse the
water filter thoroughly with clear water. Replace the filters in reverse order.
5. The filter in the water tank can be rinsed with warm water if necessary.
EN
27