Installation And Operation - Klarstein ICEWIND PLUS SMART Manual

EN
22

INSTALLATION AND OPERATION

Before first use
Remove all packing material and read the instructions completely. The unit is
ready for use immediately.
Switching on the appliance
As soon as the unit is switched on, all displays come on briefly. A double signal
sounds, the air outlet moves back from the current angle to 0° and the unit
switches to standby mode. If you do not take any action for more than 1 minute,
the display darkens to 33 % of the original brightness. Press any button to switch
the display back on.
Operation via the buttons on the control panel
• On/Off: Press the button to start the unit in normal wind mode. The air outlet
opens automatically. Press the button again to return to standby mode.
The fan stops and the outlet closes automatically. To switch off the device
completely, pull the power plug out of the socket.
• Wind speed: After the unit has been switched on, the unit is in normal wind
mode. Press the button several times to set one of the following wind speeds:
high > medium > low > quiet. If you select "low", the fan first runs at medium
speed and then changes to low speed.
• Wind mode: Press the button several times to select one of the following
modes: Normal > Natural (
indicator on the display lights up. In natural mode, the wind speed changes
regularly and the cool air is distributed throughout the room. In natural mode,
the speed is automatically controlled and not manually adjustable. In sleep
mode, the air is distributed to ensure a comfortable sleep. In sleep mode, all
speeds are manually adjustable.
Note: In natural wind mode, the "quiet" wind speed cannot be used. In natural
mode, only the wind speeds "high", "medium" and "low" can be used.
• Timer: Press the button several times to select one of the following settings:
1 hour > 2 hours > 4 hours > 8 hours. If the corresponding LED is not
lit, the timer is not active. After you have selected the desired time, the
corresponding indicator lights up on the display. As soon as the time has
elapsed, the unit switches off and the display goes out.
• Humidification or evaporative cooling: In operating mode, press the button
to switch the water pump in the unit on/off
• Swing: Press the button to swing the unit to the right and left. Press the
button again to stop the swing function.
) > Sleep Mode ( ). The corresponding