Trouble Shooting; How To Transmit Or Receive A Message - PRESIDENT Bill II Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

- Microphone sensitivity
- Maximum drain
- Modul. signal distortion
3) RECEPTION
- Maxi. sensitivity at 20
dB sinad
116 dBm FM
- Frequency response
- Adjacent chan. selectivity : 60 dB
- Maximum audio power
- Squelch sensitivity
- Frequency image
rejection rate
- Intermediate frequency
rejection rate
- Drain
G) TROUBLE SHOOTING
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR
TRANSMISSION IS OF POOR QUALITY
-
Check that the antenna is correctly connected and that
the SWR is properly adjusted.
-
Check that the microphone is properly plugged in.
-
Check that the programmed configuration is the correct
one (see table page 74).
-
You are using the same modulation mode as your cor-
respondent AM or FM.
: 7 mV
: 1.7 A
: 2 %
: 0.5 µV - 113 dBm AM / 0.35 µV -
: 300 Hz to 3 kHz
: 2.5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 180 ~ 550 mA
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEP-
TION IS POOR
-
Check that the squelch level is properly adjusted.
-
Check that the programmed configuration is the correct
one (see table page 74).
-
Check that the volume is set to a comfortable listening
level.
-
Check that the microphone is properly plugged in.
-
Check that the antenna is correctly connected and that
the SWR is properly adjusted.
-
You are using the same modulation mode than your
correspondent.
-
See the ACCESSORY VOLUME menu page 49.
3) YOUR CB WILL NOT LIGHT UP
-
Check the power supply.
-
Check the connection wiring.
-
Check the fuse.
H) HOW TO TRANSMIT OR RECEIVE A MESSAGE
Now that you have read the manual, make sure that your
CB Radio is ready for use (i.e. check that your antenna
is connected).
Choose your channel (19, 27).
Press the «push-to-talk» switch (8) and announce your
message «Attention stations, transmission testing» which
will allow you to check the clearness and the power of
your signal. Release the switch and wait for a reply. You
should receive a reply like, «Strong and clear».
If you use a calling channel (19, 27) and you have es-
51

Advertisement

Table of Contents
loading

This manual is also suitable for:

Txpr101

Table of Contents