Qlima D 720 Cube Operating Manual page 77

Wet clothes
30~50cm 30~50cm
Airflow
Allow 30~50cm
of distance on
the top and
right side of the
unit to the wet
clothes.
man_D720 Cube ('21) V3.indd 77 man_D720 Cube ('21) V3.indd 77
Setting dehumidifying mode
At setting dehumidifying mode, the unit can be adjusted in a range 35%~85%, and the
humidity setting can be adjusted (increase/decreasing) in 5%. Press MODE button to exit
setting dehumidifying mode.
Quick glance light(On some models)
When the humidity is more than 70%, the quick glance light will emit red light.
When the humidity range is at 45% to 70%, the quick glance light will emit yellow light.
When the humidity is lower than 45%, the quick glance light will emit green light.
The light can be activated or deactivated by pressing and holding the Fan button and UP
botton simultaneously for 2 seconds.
MAX mode(On some models)
The unit can make the MAX dehumidification function when it is under MAX mode. The
fan speed is fixed at high fan speed.
Dryer mode(On some models)
The unit can make the MAX dehumidification function when it is under Dryer mode. The
fan speed can't be adjusted.
NOTE:
1. The Dryer/MAX(model dependent) mode must be operated in a close room,do not
open the door and window.
2. To make the best effective dehumidification, please first dehydrate the wet clothes.
3. Make sure to direct airflow at the wet clothes.
4. For thick and heavy wet clothes may not get the best effective dehumidification.
Bucketless mode(on some models)
The dehumidifier can be used without bucket when the unit is under Bucketless mode.
The unit will not reminds the water to be full after entering the bucketless mode,
therefore, it is suggested that:
1. Check whether the tube is properly connected;
2. Link the other end of the tube to a place with unlimited capacity, such as a sink or a
basin;
3. Do not place the other end of the tube in a container with limited capacity, otherwise
the water may overflow to the floor.
Exit the bucketless mode:
1. Press FILL LEVEL and up to exit
2. Turn off the power
NOTE: It may cause an unexpected exit from the bucketless mode when the tank float
touches the micro switch (at the bottom of the unit). So please check whether the bottom
of the unit is clear under the bucketless mode.
Note:
1. Please make sure the unit is placed on a flat, horizontal table to prevent toppling and
sliding.The tilt angle needs to be less than 1 degree.
4
77
05-07-2021 14:16 05-07-2021 14:16