Advertisement
wire, which might damage the wire. With too low a pressure, the drive gets out of place, causing
the wire to run unevenly.
Reversing polarity
Certain solid wires are more suitable for being welded with the gun being attached to the negative pole;
in that case, polarity should be reversed. Check the recommended polarity on the package of the solid
wire.
1.
Pull out the plug.
2. Bend the rubber cover of the mass cable to remove the cable.
3. Remove the nuts and washers holding the poles in place. Pay attention to the order of the
washers!
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62551
Page 7
12
2021-1
Advertisement
