Advertisement
•
Never carry the device on your shoulder when welding; place it on a level surface. Do not stock
the device by hanging it up on the shoulder strap. The shoulder strap is only suitable for carrying.
•
Do not move the shielding gas bottle when the regulation valve is attached to it. Fix the gas
bottle in upright position to a separate wall rack or bottle trolley. After use, always close the gas
bottle.
Fire protection
Welding is hot work. Therefore, obey the fire regulations. Protect the surroundings from weld spatters.
Remove flammable material, e.g., flammable liquids, from the vicinity of the welding spot and have
suitable extinguishers at hand.
Note:
Fire caused by sparks may even form several hours after work.
Warning!
Welding in flammable or explosive zone is strictly forbidden.
Supply voltage
•
Do not enter a workpiece, e.g., a container, or a car together with this device.
•
Do not work on wet surfaces.
•
Do not use damaged welding cables.
•
Do not use the welding gun or earth clamp directly at the welding machine or another electric
device.
Welding fumes
Make sure that there is enough aeration. Take special precautions when welding metals that contain
lead, cadmium, zinc, quicksilver, or beryllium. Sufficient fresh-air supply can also be ensured by using
a fresh air helmet.
Using the device
•
The device comes to you with a 0.8 mm welding wire installed; thus, no further adjustment need
to be made.
•
If not using the recommended welding wire, make sure that the contact of the welding gun and
device is suitable for the size and type of the wire used.
Before using the product
The products are delivered inside a durable, special packaging. Nevertheless, before using the device,
make sure that the products have not been damaged during transport. Check as well if the packaging
contains the products that you have ordered and the required user's manuals.
Environment
•
This device is suitable both for indoor and outdoor use; however, it should be protected from
heavy rain and direct sunlight. Store the device in a dry and clean place and protect it from sand
and dust during use and storage. The operation temperature range recommended is between
–20 ℃ and +40 ℃.
•
Place the device so that it does not touch any hot surface or comes into contact with sparks or
weld spatters. Make sure that the air circulates freely inside the machine.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62551
Page 4
12
2021-1
Advertisement
