Dell Chromebook 3110 Service Manual page 58

Steps
1. Align the screw holes on the display hinges with the screw holes on the display back-cover.
2. Replace the two screws (M2.0x3.0) and the four screws (M2.5x2.5) to secure the display hinges to the display back-cover.
3. Adhere the four pieces of aluminum foil to secure the display hinges.
4. Adhere the conductive tape on the left display hinge to secure the display cable in place.
NOTE: For Chromebook 3110 systems shipped with WWAN, route the display cable along the routing channels at the
bottom-left side of the display back-cover and then adhere the piece of conductive tape to secure the display cable in
place.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the WWAN card
5. Install the base cover.
6. Follow the procedure in
58 Removing and installing components
for systems enabled with 4G LTE.
After working inside your computer.