Install The Upper Handle; Install The Grass Catcher; Set The Working Depth; Install The Battery Pack - GreenWorks GD40SC36 Operation Manual

4. Adjust the lower handle in one of the three positions.
Make sure that the two handle knobs are in the same
position.
WARNING
Do not make damage to the cables when you fold or unfold
the handle.
3.3

INSTALL THE UPPER HANDLE

Figure 3
1. Align the holes in the upper handle, the middle handle
and the lower handle.
2. Put the bolts through the holes and spacers.
3. Tighten the quick-release levers onto the bolts.
4. Do the same operation on the other side.
3.4

INSTALL THE GRASS CATCHER

Figure 4
1. Open the rear discharge flap and hold it.
2. Hold the grass catcher by its handle and put the hooks
over the slots.
3. Close the rear discharge flap.
3.5

SET THE WORKING DEPTH

The machine can be set to different working depth.
Figure 5
1. Pull the depth adjustment lever backwards to increase the
working depth.
2. Pull the depth adjustment lever forward to decrease the
working depth.
3.6

INSTALL THE BATTERY PACK

Figure 6
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Open the battery compartment flap.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
NOTE
English
5. Close the battery compartment flap.
The engine starts only when you put in the safety key.
3.7

REMOVE THE BATTERY PACK

Figure 6
1. Open the battery compartment flap
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

OPERATION

Wear eye protection during operation.
4.1

START THE MACHINE

Figure 7
1. Put in the safety key and battery.
2. Push and hold the start button.
3. While you hold the start button, pull the bail switch in the
direction of the handle bar.
4. Release the start button to start the machine.
4.2

STOP THE MACHINE

Figure 7
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
Always remove the safety key and battery pack after you
complete the work.
4.3

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge flap and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge flap.
7. Empty the grass catcher.
5
NOTE
WARNING
WARNING
WARNING
EN