Maintaining The Burner; Maintenance - Parkside PPS 40 B2 Operation And Safety Notes

Maintenance and care
• Maintenance and care

• Maintaining the burner

„
The parts displayed in Figure F are the
8d
electrode , diffuser
8c
sleeve . They can be replaced once
the nozzle clamping sleeve
unscrewed.
„
8d
The electrode
there is a crater of approximately
1.5 mm depth in the centre.
ATTENTION!
fTo unscrew the electrode, do not apply
irregular pressure, gradually increase
pressure until the thread is released.
The new electrode must be screwed into
its bracket and blocked but not tightened
up to the stop.
„
The burner sleeve
the central bore is damaged or if it has
expanded in comparison to a drilling of
a new nozzle. If the electrode
8c
burner sleeve
this can result in an overheating of the
parts. This can reduce the lift cycle of the
diffuser 8e
.
Once replaced, make sure the nozzle
clamping sleeve
sufficiently.
22 GB
8e
and the burner
8b
has been
must be replaced if
8c
must be placed if
8d
or the
are replaced too late,
8b
is tightened
ATTENTION!
fThe nozzle clamp sleeve
be screwed on to the burner
has been equipped with the electrode
8d 8e
, diffuser and burner sleeve
fIf these parts are missing, the
device may malfunction and it
may create a hazard for the
operating personnel.

• Maintenance

PLEASE NOTE!
fThe plasma cutter must be regularly
maintained for perfect function and to
comply with the safety requirements. Im-
proper and wrong operation may cause
failures and damage to the device. Have
repairs only conducted by qualified
specialists.
PLEASE NOTE!
fIt is not necessary to empty the conden-
sation water tank
lates here, then fine droplets form under
the container. The condensation water is
then dissipated through evaporation.
Switch off the main power supply and the
main switch of the device prior to carrying
out maintenance or repair work on the
plasma cutter.
„
Regularly clean the outside of the plasma
cutter and its accessories. Use com-
pressed air, cotton waste or a brush to
remove dirt and dust.
„
In case of a defect or a necessary
replacement of equipment parts, please
contact the appropriate qualified
personnel.
8b
must only
8
once it
8c
.
18
. If water accumu-