Troubleshooting Maintenance And Care - Parkside PPS 40 B2 Operation And Safety Notes

Initial cut but not
completely drilled
through?
„
Slag formation on
„
interfaces?
„
Arc stops during
cutting?
Insufficient
penetration?
Consumables
wear quickly?
„
Potential connection problem.
Tool/material creates heat.
Cutting speed too low or
current too high.
Plasma burner component
parts are worn 8b
„
Cutting speed too low.
„ 8
Plasma burner
high and too far away from
the material.
„
Plasma burner component
8b
parts are worn
„
Workpiece no longer
connected to the grounding
cable.
„
Cutting speed too fast.
„ 8c
Burner sleeve
„
Metal is too thick.
„
Plasma burner component
8b
parts are worn
„
Performance was over-
stretched.
„
Arc control time exceeded.
„
Incorrect plasma burner
assembly.
„
Insufficient air supply, pressure
too low.
„
Faulty air compressor.
Troubleshooting / Maintenance and care
„
Check all connections.
„
Allow the material to cool
down and then continue
cutting.
„
Increase the speed and/or
reduce the current until the
, 8c , 8d , 8e .
slag has been reduced to a
minimum.
„
Check and replace worn
parts.
„
Increase the cutting speed until
the problem no longer exists.
is held too
„
Lower the plasma burner
the recommended height.
„
Check and replace worn
parts.
8c 8d 8e
, , , .
„
Check the connections.
„
Slow down the working speed
„
Adjust the inclination.
is not straight
„
Several cycles necessary.
„
Check and replace worn
parts.
8c 8d 8e
, , , .
„
Material too thick, increase
the angle to avoid material
from being blown back into
the tip.
„
Do not control the arc for
more than 5 seconds. You can
also start with contact
between the burner sleeve
and metal or with a 3.2 mm
distance to the metal.
„
Check the air filter, increase
the air pressure.
„
Check the performance of the
air compressor and make sure
the inlet pressure is at least
100 PSI (6.8 bar).
8
to
8c
GB 21